![]() The software name is a bit misleading, in that it doesn't get angry, nor will it do anything malicious to your computer or router. What this software does is scan through all the IP addresses available on the network, and finds all devices that are connected to your router. I will use Angry IP Scanner, as it is really easy to use. You can get your Raspberry Pi's IP address by either going into your router and browsing through all the connected devices, or by using some IP scanning software (like Angry IP Scanner). The local IP address allows the router to identify which machine is accessing the network. To SSH into your Raspberry Pi, you will need its local IP address. During this time, the Raspberry Pi will boot up and connect to your WiFi network. Plug the power supply in, and power it up. ![]() Safely remove the SD card from your computer, and plug it into the Raspberry Pi's SD card slot. Now that we have configured for SSH and setup the WiFi, it's time to switch on the Raspberry Pi. Step 3: Accessing the Raspberry Pi (Part 1) - Network Access It will also look for the wpa_nf file to set up its WiFi. If it finds it (no matter what the file contains), it will enable SSH. What will happen now is that the Raspberry Pi will search for the ssh file in boot. Your wpa_nf file should look something like: country=GB
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |